제목 없음

2012.11.09 15:59

Reinforcement frame

Views 37555 Votes 0 Comment 0

수정1.png 

1. Construct the reinforcement frame to match the specifications set 

forth by GPO US.  (Pictured: reinforcement frame without cross bars) 



수정2.png 

2. Continue constructing the reinforcement frame, adding cross bar 

supports where necessary. 



수정3.png 

3.  Pictured: Finished section of reinforcement frame. 



수정4.png 

4.  Affix slide bracket wall mounts to reinforcement frame as shown in the 

image above.  Be sure to bolt the slide brackets to one another 

(not just the reinforcement frame).



수정5.png 

5. Ensure that the slide brackets are level and begin affixing the second 

horizontal row of slide bracket wall mounts to the reinforcement frame. 

Be sure to bolt each slide bracket to the adjacent slide bracket 

(including those both above and below). 



수정6.png 

5. Once again, ensure that the slide bracket mounts are level and affix the 

third row of slide brackets to the reinforcement frame and second row  

of slide brackets (as well as one another, as was the case with the previous horizontal row). 



수정7.png 

6. Position power outlets / DVI receiver / players.

     6-1. Power outlets must be recessed.  Outlets which are level with the   

             surrounding wall surface may lead to obstruction of the side-to-side 

             movement of the screens within the slide bracket structure.

     6-2. RS-232 cables must be daisy-chained for ease of service/updating.

     6-3. Prepare required cables (Power, DVI and RS-232)    



수정8.png 

7. Begin by inserting the first display in the bottom-left slide bracket mount.  

When the display has been raised to the level of the slide bracket mount, 

begin inserting cables. Next, insert the two casters (wheels) located at the top 

of the back-end of the display into the two notches at the top of the slide bracket mount.  

This can be done by angling the top of the display towards the slide bracket mount.  

The two bottom casters will slide into place when the display is slowly angled so that it is 

parallel to the wall surface.



수정9.png

8.  Continue inserting displays into the bottom horizontal row of slide brackets 



수정10.png 

9.  Insert the next horizontal row of displays, being careful not to strike, 

place pressure on, or otherwise damage the top bezels of the bottom row of displays.



수정11.png 

10.  Insert the final (top) horizontal row of displays, being careful not to strike, 

place pressure on, or otherwise damage the top bezels of the middle row of displays.



수정12.png


11.  Affix side covers (shown above circled in red) by screwing into slide 

bracket mounts.  Use the screws provided.  


  1. Plywood

    Read More
  2. Reinforcement frame

    Read More
Board Pagination ‹ Prev 1 Next ›
/ 1

나눔글꼴 설치 안내


이 PC에는 나눔글꼴이 설치되어 있지 않습니다.

이 사이트를 나눔글꼴로 보기 위해서는
나눔글꼴을 설치해야 합니다.

설치 Cancel

Designed by sketchbooks.co.kr / sketchbook5 board skin

Sketchbook5, 스케치북5

Sketchbook5, 스케치북5

Sketchbook5, 스케치북5

Sketchbook5, 스케치북5